Come and visit our
Coventry showroom and be inspired

55 Spon End, Corner of Hearsall Lane, Coventry, CV1 3HE

or Call us on 02476 670041

How to spring clean your woodburner

Servicing and maintenance

An annual service includes stripping and cleaning the appliance thoroughly, and one of the first things to do is to clean the inside of the firebox. To do this, wait until the stove is completely cool, and then remove all of the excess ash. Finer particles can be vacuumed up.

Next, the firebricks should be checked using a soft brush. Any that are broken or damage need to be replaced, but for smaller cracks, you can use fire cement to repair them.


Likewise, the door glass of your woodburner needs to be checked for any signs of damage. If the glass has cracked, it will need replacing, but if not, go ahead and clean thoroughly by removing it from the door and cleaning with an appropriate glass cleaner. It’s important to remember that different kinds of glass need different cleaning products – check which one is appropriate for your stove or fire by contacting us if you are unsure.

Check your stove’s door rope seal for signs of wear, as these can also become loose over time. If needed, change the door rope seal for a new one.

If both your seal and door glass are in good condition, you can fit the glass back into the door – your woodburner is now thoroughly cleaned and serviced.

Get your chimney swept

Just as your woodburner needs maintaining, so does your chimney. Anything from tar to birds’ nests can get stuck in your flue, so it’s essential to consider when you last had your chimney swept and whether or not you’ll need to do it again soon.

How often you have your chimney swept does depend on a variety of things:

• How often you use your fire or stove
• The fuel type you burn (e.g if burning smokeless fuels)
• The moisture content in the wood you burn
• What type of chimney you have

Out with the old, in with the new

Many of us make home improvements during the spring, so now could be the ideal time to replace your open fire or old stove with a new Ecodesign Ready product that is not only more efficient but also minimises emissions from wood burning.

The Ecodesign Ready scheme has been put into place to ensure new wood burning stoves and fires meet high environmental standards, minimising emissions for cleaner burning products.

Make sure that you burn good wood to get the most from your Ecodesign Ready stove or fire – it is widely known that burning bad quality, wet wood results in poor quality combustion, increased smoke and the production of tars and creosotes that will damage your flue. You can be sure that you are burning the right firewood if you check for the Woodsure ‘Ready to Burn‘ label which indicates that the firewood you have chosen is of good quality.

Information supplied by

Submit a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>